Publicité
► Ensure that the bottles are evenly distributed in the interior.
► Make sure that the base is fully inserted so that the door can be closed properly.
Removing the storage shelves:
To remove a storage shelf, first remove the bottles.
Carefully pull out the shelf until this is no longer possible.
There is a bolt in the centre that you can fold in.
Once you have folded the pin into the appliance on both sides, you can remove the shelf.
Installing the shelves:
Slide the storage shelf into the appliance and fold out the bolts on both sides to secure the
storage shelf
► Make sure that the wooden storage shelves are properly engaged before placing bottles
on them..
12.6 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or
gangs is prohibited because of the danger of fire that is involved with this.
Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.
Lay the power cable so that you do not trip over it.
This device is not designed to be installed in an RV or used with an inverter.
The electrical outlet must be protected by a 16A safety cut-out switch.
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician. The manufacturer cannot be made responsible
for damages that are caused by a missing or damaged protective conductor.
13 Operation and Handing
This chapter provides you with important notices with regard to operating the device.
13.1 Operating elements and displays
The device transmits the following signal sounds as an acoustic feedback signal:
► Use the buttons
► Temperature recommendations: Red wine: 12°C – 16°C and white wine 6°C – 10°C.
Please note
Please note
Please note
and
to set the temperature in the range of 5-20°C.
31
Publicité
