Publicité
6.3- Long Term Storage
When it is not in use for a long time and needs storing, please drain off the fuel in the fuel tank
and the cylinder. The long-term storage with fuel in them will cause the block inside the cylinder
and the failure of the engine (hard to start or lower output of the power).
1. Please leave the tank cap a bit open in storage. Being tightened may lead to the deformation of
the cap. If the pump is not in use for more than a mouth, store it at the places where there is less
dust and lower humidity after it is repaired as follows:
2. Drain off the fuel from the fuel tank.
3. Refill the pump with water and start the engine. Keep it running at low speed until the fuel is
used up.
4. Remove the spark plug and refuel 1-2cc of motor oil into the cylinder. Pull out the hand starter
2-3 times.
5. Replace the spark plug as it was and pull the starter. Release the starter grip at the position
where you feel it hard to pull.
6. Drain off the water in the pump thoroughly and wipe out the water with a rag
7. Before storing the machine, repair or replace any worn or damaged parts.
8. Remove the air cleaner element and clean with gasoline.
Rinse (to remove any gasoline excess) and dry thoroughly, then add a few drops of oil. Reassemble.
9. Store the machine in a clean, dust-free area.
Product must be stored in a dry location. Always lock up product and keep out of reach of children
6.4- Transportation
When transporting the water pump, turn off the engine switch and the fuel valve.
Keep the water pump levelled to prevent fuel spillage.
Fuel vapour or spilled fuel may ignite.
WARNING! Contact with a hot engine or exhaust system can cause serious burns or fires.
Let the engine cool before transporting or storing the water pump.
Latch or secure pump when transporting in a truck, van...to avoid any damage or injury.
6.5- Disposal
When disposing of your machine, remove oil and fuel from the machine, and be sure to follow the
local regulations. Do not dispose of in/with household rubbish.
6.6- Troubleshooting
Phenomena
Cause
The starter lead
The wheel of the starter lead is
cannot be
struck or blocked by other
pulled out.
things.
The crankshaft
The engine is burnt or blocked
is not running.
by other things.
The engine
The fuel is inferior. (Impurity,
cannot be
regenerated)
Handling method
Disassemble and repair (Competent servicing
dealer)
Disassemble the engine and replace the
damaged parts (Competent servicing dealer)
Replace it.
Page 36 of 56
Publicité
