Parkside PDZ 25 A1 Instructions D'utilisation Et Consignes De Sécurité page 8

CAUTION! RISK OF INJURY!
Keep children and other people
away from the product during use.
You could lose control of the
product if you are distracted.
Be attentive while working! Pay
attention to what you are doing.
Proceed with caution.
Avoid uncomfortable positions.
Make sure that you are standing
firmly and that your weight is
evenly balanced.
Wear suitable working clothes.
Wear tight-fitting clothing, non-slip
shoes, a hairnet, or tie back your
hair. Jewellery or loose-fitting
clothing can get stuck in moving
parts of the product.
Keep your workplace clean.
Disorder can lead to accidents.
Do not use the product in a damp
or wet environment.
of the work environment must
wear protective goggles and
earmuffs.
Remove the product from the com-
pressed air source before repair
and maintenance work and be-
fore transport.
Do not carry the compressed air
device by the hose, but by the
housing instead.
8 GB/IE/NI
Every person in
the direct vicinity
Do not kink the compressed air
hose. This could cause damage.
NOTE! Please observe all manu-
facturer's instructions regarding
inflatable articles.
Use
Note: Please remove all packaging material from
the product.
Note: Lag all male threads on the pneumatic
accessories with thread sealant
Note: Always operate the product with compressed
air that is clean, oil-free and moisture-free. Do not
exceed the maximum working pressure of 10 bar
at the device.
Connect with compressor
Connect the spiral hose
pling , and quick plug nipple
2
connect to a suitable compressed air source
(see Fig. A).
To break the connection, pull the sleeve of the
quick coupling back and pull the quick
2
plug nipple or
3
off the compressor when you do not wish to
use it anymore.
Using the air blow gun
Connect the blow gun
(see Fig. B).
4
Connect the blow gun to the compressed air
source (see section „Connect with compressor").
For your own safety, a permanent hose con-
nection between the blow gun
spiral hose is not recommended.
1
Press the compressed air supply trigger to release
compressed air. The longer you hold down the
trigger, the greater the compressed air output.
Let go of the trigger to stop the compressed air.
.
6
to the quick cou-
1
and then
3
out. Remember to turn
4
with an air plug nipple
5
and the
5