Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
These installation instructions cover different models. The
appearance of your particular model may differ slightly from the
illustrations in these Installation Instructions.
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Tape measure
■
#2 Phillips screwdriver
■
Drill
■
Parts supplied
The Microwave Drawer is preassembled.
1" (2.5 cm) mounting screws (4)
■
1" (2.5 cm) deflector screws (2)
■
Flush mount deflector (1)
■
Verification needed
Installer must confirm presence of anti tip block. Refer to the
■
anti-tip block section in the manual.
Check local codes. Check existing electrical supply. See
■
"Electrical Requirements."
It is required that all electrical connections be made by a
■
licensed, qualified electrical installer.
Location Requirements
This product is suitable for use below electric or gas built-in
ovens. This product is not suitable for use below cooktops.
The Microwave Drawer may be located in a cabinet or below
the counter, and/or below a built-in oven. Check the opening
where the Microwave Drawer will be installed. The location must
provide:
IMPORTANT: Observe all governing codes and ordinances.
Wood cabinetry.
■
Cutout opening that is plumb and square. See "Minimum
■
Cutout Dimensions" in the "Minimum Dimensions" section.
Cutout floor that is solid, level, and flush with bottom of
■
cabinet cutout.
Support for weight of at least 100 lbs (45.4 kg), which
■
includes Microwave Drawer and items placed inside.
Grounded electrical outlet. See the "Electrical Requirements"
■
section.
Minimum installation clearances for installation location. See
■
the "Minimum Dimensions" section.
Complete enclosure around the recessed portion of the
■
Microwave Drawer.
07-Aug-2017 04:52:48 EDT | RELEASED
INSTALLATION REQUIREMENTS
/
" (3.17 mm) drill bit
1
■
8
Marker or pencil
■
In some European factories the letter "W" of the part code mentioned herein will be automatically
Minimum Dimensions
Minimum Wall Oven Combination Installation
Clearances
For proper installation, the following minimum clearances must
exist above and below the cutout opening.
NOTE : Upper oven must have heat deflector kit installed to
direct exhaust away from microwave console (Refer to Wall Oven
Manual for Deflector Kit Installation)
A
2" (5.1 cm)
B
A. Upper oven cutout
B. Microwave drawer cutout
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
3
Publicité
Table des Matières
