LENCO PR2700 Mode D'emploi page 26

The Alarm is activated:
1.
The alarm on will only work in standby mode
2.
When the alarm is sounding, the ALARM Symbol on the display will flash.
3. When the alarm is sounding, Pressing the MEMORY/ALARM button will stop the alarm.
4.
When the alarm is activated, press the SNOOZE/DIMMER to stop the alarm for 9 minutes. (the snooze function
can be active for 1 hour).
Remark: Alarm volume value is last power off
7. System display Backlight:
The brightness of the display can be changed.
Dimmer:
1. press the SNOOZE/DIMMER button repeatedly to select different brightness of the display screen:
brightness 1  brightness 2 brightness 3
8. VOLUME
Use the VOL+/VOL- buttons to adjust the volume between 0 and 32 (Default value is 15).
The volume level setting will be stored when the unit is powered off. When powered on again the last known
volume level will be used.
9. RADIO FREQUENCY TUNING
For tuning you can use the SKIP+/SKIP- buttons.
Radio preset programming
A total of 20 FM stations can be stored in the system memory.
1. In Tuner mode you can use SKIP+/SKIP- buttons to scan for your favorite station. To save it as preset, press the
MEMORY button for 2 seconds. "P01" will be blinking on the display. Use the SKIP+/SKIP- keys to select the
desired preset number (max 20) and press the MEMORY button again to store the preset.
2.
Note: If you don't press any key within 10 seconds the unit will close the programming mode and no preset will
be stored
26