Publicité
4.
Turn the lever toward the power unit.
1
Fig.11
► 1 . Lever
Make sure that the surface of the lever is parallel to the
pipe.
NOTICE:
Do not tighten the lever without the
attachment pipe inserted. Otherwise the lever may
tighten the entrance of the drive shaft too much and
damage it.
To remove the pipe, turn the lever toward the attach-
ment and pull the pipe out while pressing down the
release button.
Fig.12
Fig.12
► 1 . Release button 2. Lever 3. Pipe
Removing or attaching the blade
cover
To remove the blade cover, push the blade cover toward
the inside and turn it.
Fig.13
► 1 . Blade cover
1
2
1
To attach the blade cover, hook the blade cover to one
side of the weeding blade, and then turn it.
Fig.14
► 1 . Blade cover
NOTE: You can attach the blade cover to the pipe as
shown in the figure.
1
Fig.15
3
► 1 . Blade cover
Installing or removing the weeding
blade
CAUTION:
always wear gloves so that your hands do not
directly contact the weeding blade.
CAUTION:
removing or installing the weeding blade.
1.
Attach the blade cover to the weeding blade.
7 ENGLISH
1
When replacing the weeding blade,
Attach the blade cover before
Publicité
