Publicité
3.
Make sure that the weeding blade is engaged with
the adjusting plates.
Fig.6
4.
Insert the bolt from the side without the nut and
tighten the bolt with the wrench.
Make sure that the bolt is securely tightened.
2
1
Fig.7
► 1 . Bolt 2. Nut
NOTE: Tightening torque : 5 - 10 N•m
Mounting the attachment pipe
CAUTION:
Always check that the attachment
pipe is secured after installation. Improper instal-
lation may cause the attachment falling off from the
power unit and cause personal injury.
Mount the attachment pipe to the power unit.
1.
Remove the cap from the end of the pipe.
1
Fig.8
► 1 . Pipe 2. Cap
NOTICE:
Do not dispose of the cap since the cap
is necessary for storing the attachment.
2.
Turn the lever toward the attachment.
Fig.9
► 1 . Lever
3.
Align the pin with the arrow mark on the power
unit. Insert the pipe until the release button pops up.
Make sure that the position line is on the tip of the arrow
mark on the power unit, and the arrow mark on the
power unit and the arrow mark on the pipe are facing
each other.
Fig.10
► 1 . Release button 2. Arrow mark on the power unit
3. Pin 4. Position line 5. Arrow mark on the pipe
6 ENGLISH
2
1
1
2
3
4
5
Publicité
