Publicité
3.1
general transmitter layout
note:
The remote control is optional for the BL36-2 and BL46-1 models.
The receiver switch must be in the REMOTE position for the transmitter to function. This remote system operates
using radio frequency signals sent by the transmitter to the receiver. It is recommended that the distance between
the transmitter and receiver never exceeds 20' and 10' if the receiver is located within the fireplace's outer or inner
cavity surrounding an insert. Low batteries will also affect operational distance.
LCD
DISPLAY
SIGNAL
INDICATOR
THERMOSTAT
BULB
THERMOSTAT
SET
TEMPERATURE
CHILD-PROOF
FUNCTION
INDICATOR
ON / OFF
BUTTON
UP
BUTTON
3.2
temperature display
Remove the battery cover on the back of the transmitter to expose the °C /
°F dip switch. Move the dip switch to your desired temperature mode.
Selected temperature mode will appear in the top right corner beside the
room temperature.
Batteries must be disposed of according to the local laws and regulations. Some batteries may be
recycled, and may be accepted for disposal at your local recycling center. Check with your
municipality for recycling instructions.
3.0 remote control layout
remote control layout
TEMPERATURE
ON
OFF
TEMPERATURE
INDICATOR
INDICATOR
BATTERY
INDICATOR
THERMOSTAT
ROOM
FLAME
LOW
BUTTON
DOWN
BUTTON
TRANSMITTER
REAR VIEW
°F
°C
AAA
AAA
W415-4193 / A-0 / 07.23.24
EN
11
Publicité
