Emptying The Ultrasonic Tank; Fixing And Removing Of The Outlet At Tk 100 H - Bandelin Sonorex Super Mode D'emploi

3.5. Emptying the ultrasonic tank

Pull the mains plug.
Do not place the unit into a sink.
Units with drain
• Ball cock
Turn the lever to the outflow
direction.
• Outlet hose, closing cap or hose clamp
When unscrewing the closing cap or unlocking the hose clamp, make sure that the
hose end is in a higher position than the liquid level in the oscillating tank. – It is
possible, that the hose (at the clamp position) does not open immediately caused by
quenching.
Units without drain
Pour out the liquid over one of the tank corners.
Avoid splashing from below.
4.

Fixing and removing of the outlet at TK 100 H

TK 100 H
Back view
5
1
3
For fixing the outlet, push the angled fitting over the outlet pipe at the back of the unit.
The angled fitting can be removed by pressing the small ring to the fitting with a small
screw driver and pulling it from the outlet pipe, simultaneously.
Do not tilt!
2 4
- 17 -
Outlet:
1 angled fitting
2 tube
3 fixing clamp
4 closing clamp
5 tube support
Detail A:
Ring