Installation; General - Pelgrim WA300RVS Mode D'emploi

Masquer les pouces Voir aussi pour WA300RVS:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION

General

EN 10
This appliance should be connected to the power supply by a
recognized fitter who is familiar with, and works according to the
correct safety regulations. This appliance meets the European
requirements.
Important that you know:
• The minimum distance between the supporting surface for the
cooking vessels on the gashob and the lowest part of the range
hood must be not less than 65 cm. For use with an electric, ceramic
or induction hob, this distance must be at least 55 cm.
• If the cooker hood is to be fitted to an existing duct no other
appliances, such as a geyser or heater, may be connected to that
same duct.
• Consider local regulations with respect to the ventilation of gas
appliances.
• The shorter the duct, and the fewer the bends in it, the better the
cooker hood will work.
• Before you start drilling check that there are no installation cables
present.
• The connecting pipe for the cooker hood has a diameter of
125 mm. It is best also to use a flue pipe of the same diameter.
• The installation material supplied with this range hood is designed
for fixing to reinforced concrete or masonry walls. For some types
of walls you may need special plugs and screws.

Publicité

Table des Matières
loading

Table des Matières