Publicité
PE 2008T
PE 2003T
3.5 LIFT IDENTIFICATION AND PICTOGRAMS DESCRIPTION
The safety signals (Fig. 5) described in this manual are applied onto the lift (Fig. 6), and
warn about unsafe and hazardous situations. Decals shall be kept clean and, if detached
or damaged, they shall be immediately changed.
Carefully read the meaning of the safety signals, and memorise it:
1
Instructions plate
Manufacturer's logo
3
4
Max. load
Carriage alignment
5
6
Plaquette CE
A
Serial No.
B
Type
C
Model
D
Max. Load
E
Ground
F
Manuf.year
G
Voltage
Each lift is supplied with the identification plates (6, Fig.5) relating to the different versions. Data
(A) and (B) have always to be mentioned for any service and spare parts need.
WARNING: Once the assembly has been carried out, the operator should apply the
identification plate, according to the installed lift version, onto its proper position
(6, Fig. 6).
3.6 INTENDED USE
The vehicle lifts described in this manual are designed and manufactured for lifting vehicles for
inspection, maintenance and/or repair purposes only.
The vehicle lift should be used only for lifting vehicles within the load capacity limits given in the
IDENTIFICATION PLATE (6, Fig. 5) and in the paragraph 1.3 «LOAD DISTRIBUTION» (Fig. 3).
66
PE 2009T
H
TFreq.
I
Power
L
Pressure
M
Absorption
BEFORE USING THE LIFT BRIDGE, READ THE CONTENTS OF THIS
MANUAL CAREFULLY.
7
Column greasing
8
Danger signal. Voltage on.
9
Danger signal. Risk of feet shearing.
10
Danger signal. Fall possibility. Do not get
up on the runways
11
Danger signal. Before carrying out
any maintenance operation, stop the
equipment and consult the user's manual
12
Safety device
13
Load distribution
14
Vertical logo
Publicité
