Publicité
Installation
*
A
A
30
English
Untitled-1 30
CAUTION
• Connect the hose guide (A) within 3–5 in. (7.6–
12.7 cm)* from the end of the drain hose. If the drain
hose is extended beyond the end of the hose guide,
mold or microorganisms could spread inside the
washer.
• The drain hose can be installed up to 96 in. (245 cm)
high, but the draining capability can be reduced at
the maximum height. Water remaining in the drain
system may cause an odor.
• If the drain hose is installed less than 18 in. (46 cm)
high, water can be drained during the process due
to a siphon phenomenon. If this happens, a '4C'
information code appears on the display.
To position using the pipe connector
You washer comes with a pipe connector that is designed
to join the upper drain hose and the lower drain hose.
You can choose to use the connector to combine two
drain hoses into a single outlet.
1. Insert the clamp ring on the end of the drain hose,
one for each drain hose.
2. Insert the pipe connector into the drain hoses. Make
sure the longer side (A) fits into the drain hose
running from the lower washer.
3. Fix the position of the clamp rings near the end of
each hose.
NOTE
To remove the pipe connector, follow these steps above
in the reverse order.
2023-06-27
7:20:07
Publicité
