Publicité
Installation
Water supply
Water pressure less than 20 psi (137 kPa) may cause the water valve not to close completely. Or, it may take
longer to fill the drum, causing the washer to turn off. Taps must be within 4 feet (122 cm) from the rear of
the washer so that the provided inlet hoses reach the washer. To reduce the risk of leaks:
To reduce the risk of leaks:
• Make sure taps are easily accessible.
• Turn off the taps when the washer is not in use.
• Check for any leaks at the water inlet hose fittings on a regular basis.
CAUTION
Before using the washer for the first time, check all connections at the water valve and taps for any leaks.
Drain
Samsung recommends a standpipe 18 inches (46 cm) high. The drain hose must be connected through the
clamp ring to the standpipe, and the standpipe must fully cover the drain hose.
Flooring
For best performance, the washer must be installed on a solid floor. Wood floors may need to be reinforced
to minimize vibration and/or unbalanced loads. Carpeting and soft tile surfaces do not provide good
resistance to vibrations and may cause the washer to move slightly during the spin cycle.
CAUTION
Do NOT install the washer on a platform or a poorly supported structure.
Water temperature
Do not install the washer in areas where water may freeze as the washer always retains some water in its
water valves, pumps, and/or hoses. Frozen water left in the connection parts may cause damage to belts,
the pump, and other components of the washer.
20
English
Untitled-1 20
2023-06-27
7:20:04
Publicité
