Publicité
Installation
26
English
Untitled-1 26
4. Put the other ends of the hoses into a bucket and
open the taps for 10-15 seconds to remove impurities.
When done, close the taps.
5. Connect the other ends of the water hoses to the
corresponding inlets on the rear of the washer as
specified. Make sure the hot water hose is connected
to the hot inlet, and the cold water hose to the cold
inlet.
6. Repeat step 2 on the other fittings. Make sure both
water hoses are connected properly. See the '4C'
information code for troubleshooting.
2023-06-27
7:20:05
Publicité
