Publicité
2) Use extra deep sockets in place of extension bars where possible.
3) Do not use oversized, worn or cracked sockets.
4) Hold the wrench so the socket fits squarely on the fastener. Hold
the wrench firmly, but not too tightly, pressing forward slightly.
Dismantling & Assembly Instructions
Disconnect tool from air supply.
Unscrew hammer case cap screws (38) and take off hammer case
(36). Take out hammer case pilot (35) and anvil (39, 39B or 39C)
from hammer case (36). Release hammer (34) by removing
hammer pin (33), then take off hammer frame rear washer (19)
and motor clamp washer (31).
Grip or support housing (1) and shake up and down to allow cylinder
(24) to fall free. Take off front end plate (28), cylinder dowel (25),
cylinder (24) and 6 rotor blades (27) in order. Unscrew rear rotor
bearing retainer (23) and take out rotor (20).
Grip motor housing (1) and tap out trigger pin (9) by using a 3.5
mm suitable pin. Remove reverse valve knob screw (16) to take
off reverse valve knob (15) and drive reverse valve (12) from
reverse valve bushing (10). Be careful not to loose reverse valve
detent ball (13). Turn air inlet bushing (6) and pull out valve spring
(4), throttle valve bushing (2) and throttle valve stem (5).
Reassembly
Clean all parts and examine for wear, etc., and replace any parts
excessively worn with only parts obtained from the manufacturer
or an approved distributor. Lightly coat all parts in a suitable
pneumatic tool lubricating oil and pack bearings and gears with a
lithium or molybdenum based general purpose grease and
reassemble in the reverse order.
250 Snap-on Drive, P.O. Box 1596, Murphy, NC, 28906, USA
Model 5000A/5000AL/5000AP Impact Wrenches, Serial Number
to which this declaration relates are in conformity with the following standard or standards or other normative document or
EN 792, EN 292 Parts 1& 2, ISO 8662 Parts 1 & 7, Pneurop PN8NTC1
89/392/EEC as amended by 91/368/EEC & 93/44/EC Directives.
Mark S. Pezzoni (President Power and Specialty Tools)
DECLARATION OF CONFORMITY
Sioux Tools Inc.
declare under our sole responsibility that the products
documents:
following the provisions of
Page No 3
Operation Specification
5000A/5000AP
Air Consumption
Maximum Torque
Operating Torque
Air Inlet Thread
Overall Length
7.3" (185 mm)
at 90 PSIG/6.2 bar
Notes
Name and signature or equivalent marking of authorized person
5000AL
4.2 cfm (30 scfm)
425 ft.lbs. (578 Nm)
25-300 ft. lbs. (34-408 Nm)
1/4-18NPT
9.3" (236 mm)
Printed in Taiwan
Publicité
