Publicité
STEP 10
Connect the Pulse Sensor Wire (5) with the Handlebar Wire-Stop (91). Next connect Computer
Wire (131) with Handlebar Wire-Level (92). Then connect the Computer Wire (104) with
Console Cable (1). Next slide Computer (103) onto Front Post (87) and secure with 4*Phillips
Screws (125). Make sure to tuck the wires into the Front Post (87) so as not to pinch the wires.
STEP 11
Insert the Left Handlebar (93) into the Left Swing Bar and fasten with 2 sets Carriage Screws (123)
and Allen Screws (124). Follow the same procedure to assemble the Right Swing Handlebar (96).
After the Handlebars are secure, attach the Swing Bar Cover-Front(94) and Swing Bar Cover-Rear
on both sides with Phillips Screws (125) 2 on each side.
93
96
23
Publicité
