Unpacking And Cleaning; Assembly; Stand Assembly - Delta BS150LS Manuel D'utilisation

UNPACkINg AND CLEANINg

Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from
unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.
Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your
machine.
After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
ASSEMBLY TOOLS REQUIRED
1. 3mm Hex Wrench - provided
. 4mm Hex Wrench - provided
3. 5mm Hex Wrench - provided
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately  to 3 hours.

STAND ASSEMBLY

1. Assemble stand as shown in Fig. 4, using parts
shown in Fig. 3. The brackets and legs are identified
with the same letter in both illustrations. Insert the
M8 x 16mm carriage head screws through the legs
and the brackets then place the 3/8" flat washers
followed by M8 lock washers on the screws and
secure with the M8 hex nuts. Only tighten nuts finger-
tight at this time. NOTE: The top lips of top brackets
(A) must fit on top of the front and back brackets
(B).
. Attach the four plastic feet (1) Fig. 4 to the bottom of
each leg (L).
BAND SAW TO STAND ASSEMBLY
1. Fig. 5 illustrates the four through holes (A) which will
be used to secure the band saw to the stand.
. Place the band saw on top of the stand and line up
the holes (A) Fig. 5 with the holes (D) Fig. 6 on the
top brackets of the stand.

ASSEMBLY

4. M8 Socket - not provided
5. M8 Wrench - not provided
A
E
1
D
8
B
L
Fig. 4
A
A
Fig. 5
Fig. 6
C
D