Checking The Bevel; Cleaning The Pump - Delta 96-107 Manuel D'utilisation

Checking the Bevel

1. Position the worktable (4) so that it is under the blade.
2. Loosen the blade cover lock knob.
3. Swing the blade cover (9) open.
4. With the bevel indicator at 0 degrees, use a framing square
to ensure the blade is square with the table.
5. If the blade is not square to the sliding table, adjust the
positive stop screw (A) in the direction that the blade needs to
move in order to square it to the table. Use a small square to
check blade to table squareness.
6. Repeat steps 4 and 5 with the bevel indicator set 45 degrees
and using the 45 degree positive stop (C).
7. To adjust pointer (B) to align to 0° or 45° mark on scale
loosen screw on pointer and adjust to align to correct mark
and re-tighten screw.
8. Close the blade cover and re-lock

Cleaning the Pump

Remove the front plate and the impeller, and use a small brush
or stream of water to clean up any debris.
The pump shaft cannot be removed.
If the water from the pump is reduced
or has stopped, replace the pump or
have it repaired by the qualified personnel.
Some dust created by power sanding,
sawing, grinding, drilling, and other
construction activities contains chemicals known [to the State
California] to cause cancer, birth defects or other reproductive
harm.
Some examples of these chemicals are:
• Lead from lead-based paints.
• Crystalline silica from bricks and cement and other masonry
products.
• Arsenic and chromium from chemically treated lumber.
Your risk from these exposures varies, depending on how
often you do this type of work. To reduce your exposure to
these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are
specially designed to filter out microscopic particles.
Removing the Water Nozzle
It may be necessary to remove or replace the nozzle. If so use
perform the following steps:
1. Use the on-board Allen wrench (5b) to loosen the cap screw
(C).
2. Flip the retaining arm (D) up and release the nozzle and
hose assembly.
3.Grasp the hose and pull the nozzle firmly to disconnect the
nozzle from the hose.
MAINTENANCE
17
B
A
Figure 26
D
C
Figure 27