Electrolux EHF3320FOK Notice D'utilisation page 29

Problem
You cannot activate the
outer ring.
There is a dark area
on the multiple zone.
The sensor fields become
hot.
comes on.
comes on.
and a number come on. There is an error in the
E6 comes on.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass
surface) and an error message that
comes on. Make sure, you operated the
Possible cause
You decreased the heat
setting to .
It is normal that there is a
dark area on the multiple
zone.
The cookware is too large
or you put it too near to the
controls.
Automatic Switch Off oper‐
ates.
The Child Safety Device or
the Lock function operates.
hob.
The second phase of the
power supply is missing.
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
ENGLISH
Remedy
Start from and only in‐
crease the heat setting.
Activate the inner ring first.
Put large cookware on the
rear zones if possible.
Deactivate the hob and ac‐
tivate it again.
Refer to "Daily use" chap‐
ter.
Disconnect the hob from
the electrical supply for
some time. Disconnect the
fuse from the electrical
system of the house. Con‐
nect it again. If comes
on again, speak to an Au‐
thorised Service Centre.
Check if the hob is correct‐
ly connected to the electri‐
cal supply. Remove the
fuse, wait one minute, and
insert the fuse again.
29