Publicité
Installation instructions
CAUTION: The camera's base should be attached to a structural
object, such as concrete, hard wood, wall stud or ceiling rafter
that supports the weight of the camera. If necessary use appro-
priate mounting material (e.g. anchors) instead of the material
enclosed with the camera.
1. Locate the mounting template at the installation position and drill the ceiling or
wall.
2. Open the dome cover by loosening screws (4x12mm). Use the torque wrench
supplied.
•
screws (4x30mm).
• Route the Ethernet & Power cable to the connecting place.
3. Connect the dome cable with the power source cable.
4. Set the camera's viewing angle.
5. If necessary, connect the Wireless connect dongle to Wireless connect connector port
of the camera then adjust the zoom/focus setting by web menu.
6. Remove the Wireless connect dongle after completing the settings.
7. Put the dome cover to the dome base unit and tighten the assembly screws.
Torque Wrench
Plastic Anchor (6x30mm)
Mounting Screw (4x30mm)
EN
7
Publicité
