For Your Safety; Designated Use; Safety Instructions - Waldmann LUMATRIS MSAL 24 Mode D'emploi

For your safety

1. For your safety
The light has been designed in accordance
with state-of-the-art standards, manufac-
tured with utmost care using high-quality
materials, and tested.
Nevertheless, its use may constitute a risk
to persons or cause material damage.
X Read all enclosed instructions and infor-
mation.
X Please observe the warnings included
in the documentation and attached to
the unit.
X The device must only be used in tech-
nically perfect condition, and only by
persons being aware of the risks and
dangers involved in operating the
device.
X Keep this document available near the
device.
1.1

Designated use

Machine light for illuminating items on and
in machines.
Suitable for wet locations.
1.2

Safety instructions

Explosion hazard
Operating the light in rooms subject to
explosion hazards can trigger an explosion
and result in serious injuries or death.
X Do not operate the light in rooms sub-
ject to explosion hazards.
Danger due to electric current
Improper use and faulty work on the light
may result in injuries and material damage.
X This product must be installed in accord-
ance with the applicable installation
code by a person familiar with the con-
struction and operation of the product
and the hazards involved.
X Compare the mains voltage with the
nominal voltage and the frequency
specified on the rating plate and make
sure that they are identical.
X Operate the light with safety extra low
voltage (SELV) only.
X Have maintenance and repair work car-
ried out by a trained electrician only.
X Before performing work on the light,
disconnect the light from the power
supply.
Risk of blinding caused by bright light
source
Looking directly into the light source may
cause temporarily impaired vision and after-
images. This may result in irritations, incon-
veniences, impairments or even accidents.
X Do not look into the light source.
X Position light in such a way that looking
directly into the light source is avoided.
Risk of burns
Hot surfaces can result in burns to the skin.
X Do not touch the light during operation.
X Do not touch the light until it has cooled
down.
ENG
15