VINCENT KHV-111MK Manuel D'utilisation page 18

Set up the cable links in a sequence as follows. Connect the power cable between device
and power supply only after all other connections have been made.
Protective caps
Prior to the first installation the protective plastic
caps must be removed from all the connections
used at the rear of the unit.
RCA connections
Mechanically identical RCA plugs are available for
analogue and digital outputs. Make sure that you
do not get these connections confused during
installation!
Make sure that you do not mix up the analogue con-
nectors for right and left. The RCA plugs for these are
mostly colour coded as follows: red for the right
channel, black or white for the left channel.
CONNECTION OF THE HEADPHONES
A set of headphones equipped with a 6.3 mm jack can be plugged into the "PHONES" socket (5) on the
front of the appliance. All headphones with an impedance of between 32 Ohm and 600 Ohm may be
used. Unsuitable headphones with too low impedance may damage the amplifier or produce such unex-
pectedly loud volume that your hearing may be damaged. The Volume setting "LEFT" and "RIGHT" (3)
should be reduced for safety reasons before a set of phones is connected.
KHV-111MK
Vincent
18
INSTALLATION
DURING INSTALLATION PLEASE OBSERVE
THE FOLLOWING ADVICE:
1 2
O UT PUT O U
6.3 mm jack connection
Cable connections
Make sure that all plugs fit tightly. Inadequate con-
nections can cause noise interference, failures and
malfunctions.
- wrong -
To make the most of the components' sound poten-
tial, only high quality loudspeakers and connecting
cables, for example Vincent cables, should be
used. Your local stockist will be glad to advise you
about this.
- correct -
headphones