Installation Procedure - Toto Neorest II Série Manuel D'installation

1) Slide the gasket onto the drain
fitting.
3) Apply a continuous bead of
sealant to the underside of the
drain fitting and
verify there are
no leaks.
CAUTION
1) Clean the mounting surface with a
soft clean cloth.
3) Insert the
threaded rods
into the mount-
ing holes at the
bottom of the
lavatory.
* NOTE: Do not over-tighten the wing nuts. Over-tightening may damage the lavatory.

INSTALLATION PROCEDURE

Installing the Drain Fitting
Drain
Fitting
Gasket
Sealant
Installing the Lavatory
Cleaning Cloth
Lavatory
4) Place the lavatory
onto the counter-
Screw-
top.
driver
Threaded
Rod
2) Install the drain fitting into the
lavatory outlet.
4) Install the mounting nut and tail
piece section.
Gasket
Slip Washer
Drain Nut
Tail Piece Section*
* Tail Piece not included
2) Apply a continuous bead of sealant (not
included) or the sealing gasket (shown
below).
4
Drain Fitting
Lavatory
Adjustable
Wrench
Sealing Gasket (optional)
Lavatory
5) Place the washers onto
the threaded rods and
install the wing nuts* .
Threaded Rod
Washer
Wing Nut