Troubleshooting - Toto Neorest II Série Manuel D'installation

1) Connect the water supply to the faucet according to the faucet instructions.
2) Connect and tighten the trap to the drain.
3) Turn on the water supplies to the faucet.
4) Purge any air from the hot and cold water by running the water for a few
seconds.
5) Fill the lavatory with water.
6) Check for leaks at the water supply and drain connections.
1) Run a continuous bead of caulk (not
included) around the sides of the lava-
tory.
2) Wipe away any excess sealant (caulk)
and fill any voids as necessary.
Allow the sealant to set for approxi-
mately 30 minutes.
„ Check that the toggle switch located on the power adapter is turned on.
„ Verify that the wall outlet and switch are working properly.
„ Verify that the power adapter is plugged into the wall outlet.
„ Verify that the LED connector is connected to the power adapter connec-
tor.
„ Inspect all wiring for damage.
INSTALLATION PROCEDURE
Faucet Connections (not included)
Final Caulking

TROUBLESHOOTING

6
Caulk
(Sealant)