Installation Procedure - Toto GR TLG02301U Manuel D'installation Et D'utilisation

Faucet
1. Place gaskets under spout.
Pass the supply hoses and mounting
studs through the mountin holes until the
spout comes to rest.
2. Orient the spout as needed. From
below the mounting surface, place the
crescent shaped washer over the mount-
ing studs as shown.
Fasten the mounting nuts to the studs to
secure the spout.
Tighten with wrench as needed.
Connect the hoses to the supply lines.
The left hose (marked with red band)
connects to the hot water supply. The
right hose connects to the cold water
supply.
Tighten with wrench as needed.
3. Insert the drain lift rod through the open-
ing in the back of spout.

INSTALLATION PROCEDURE

4
Mounting Studs
Washer
Spring Washer
Mounting Nut
Supply Hoses
Spout Body
Gasket
Drain
Lift Rod