GB
I
MAINTENANCE
Recyrculation filters - (cod.AFCFCARFH10 - AFFCARFPH6)
Filters can be restored in the oven, better if fan-assisted.
Temperature of the oven should be 150°-180°, higher temperatures could damage the filters.
It is better to place the filter bricks on the oven's grid, non pre-heated, and let them cool down
completely before removing.
The time needed to restore the filters is at least two hours or even more, depending on the
cooking intensity. Restoring should be done only in a well-ventilated place.
Do not wash the filters in the dishwasher.
Recyrculation filters can be restored many times, but for a better efficiency we recommend to
replace every 1 years.
Recyrculation filters Twin- (cod.AFCFCAIA01 )
The used filters in this hob are combined filters for grease and odour filtering. These TWIN filters
are regenerable and need periodical maintenance.
• After 30 operating hours, 'F' and 'G' will be shown alternately in the display of the extraction
unit; it is necessary to wash the TWIN filters.
• The twin filters must be washed without any detergents.
• The twin filters can be washed in the sink with hot water or can be put in the dishwasher with a
quick wash program, without any other dishes (to avoid the presence of fats or oils)
and at recommended temperatures not exceeding 60/65 °C.
• The twin filters can be dried naturally by covering them with a clean, residue-free cloth or in an
oven with top and bottom heat at a temperature of 80 °C for no longer than 1 hour.
You need to replace the TWIN filters:
• when you notice that the odour filtering is not sufficient anymore (the average time is after 240
operating hours).
• after 1 year of use at the latest.
• when the filters are clearly damaged.
ATTENTION: Drying must never be carried out with air flows. It is important that the TWIN filters are
properly dried before installation. After the maintenance, reset the memory of the filter saturation
indication.
FUNZIONAMENTO
OPERATION
84
84