The motion sensor can also be activated or deactivated by pressing and holding the "P" button
in standby mode.
PIR OFF TIME
With this function you set the delay time after which the device switches off after no motion
detection. You can set the delay time 1-10 minutes.
You can setup Alarm 1 and Alarm 2.
SET THE ALARM
1. When the unit is turned on, press and the "I/M" button, select the point "SYSTEM" with " "
or " " button and press "VOLUME / ENTER" to confirm.
2. Select the point "Alarms" and "VOLUME /ENTER" to confirm.
3. Select "Alarm 1" or "Alarm 2" and press "VOLUME / ENTER" to confirm.
4. Set the alarm time and confirm with the "VOLUME / ENTER" button again.
5. Select the wake up source (DAB, FM or Buzzer) and press again "VOLUME / ENTER".
6. Select the wake up frequency (Daily, Once, Weekends, Weekdays) and confirm the
selection with "VOLUME / ENTER".
7. Now adjust the volume level with the with " " or " " button and press the "VOLUME /
ENTER" knob.
NOTE: Set the highest volume level with the "VOLUME / ENTER" knob!
8. If you want to activate the alarm, set "Alarm on". If you want to deactivate the alarm, set
"Alarm off". When the alarm is activated, the alarm icon is shown in the display.
SNOOZE
When the alarm sounds, press any key (except the "POWER / MODE" button) to activate the
snooze function. The alarm sounds again after 5 minutes. During the snooze function, you can
change the snooze time with " " or " ".
TURN OFF ALARM
When the alarm sounds, press the "POWER / MODE" button to deactivate the sounding alarm
tone.
ACTIVATE / DE-ACTIVATE THE ALARM
Follow steps 1-8 under "SET THE ALARM" (see above). If you want to activate the alarm, set
"Alarm on". If you want to deactivate the alarm, set "Alarm off". When the alarm is activated, the
alarm icon is shown in the display.
USING THE SYSTEM MENU
To cycle through the options in a menu, press the " " or " " button.
●
To confirm a selection, press the "VOLUME / ENTER" knob.
●
To adjust a value (e.g. hour time), press the " " or " " button and then press the
●
"VOLUME / ENTER" button.
To go back to the previous menu/screen, press the "I/M" button.
●
ALARM
SYSTEM SETTINGS
5
DAB60 / English Instruction Manual