Publicité
Installation Instructions - Dual Integrated Installation
STEP 10 FINAL EXTERNAL UNIT PREPARATION
FOR FLUSH INSTALLATION:
of the door is flush with the front face of surrounding
cabinets BEFORE securing brackets to the surrounding
cabinetry.
Open the doors to
the units. Locate
removal tool. Filter
should be as shown.
counterclockwise
needed).
remove. NOTE: Water
Predrill 1/16" holes is both the sides of the surround
1/2" deep through holes in the enclosure.
CAUTION
Use gloves and arm guard when
installing spacers.
Secure unit to surrounding cabinetry using the spacers
and 1" Phillips screws provided with the unit. On Single
Door models: Secure the handle side first before
moving the hinge side. On French Door models, open
one door and secure that side before moving to the
other side.
Open door to full extension and pass arm through
opening between door and case to align spacers. Slide
the spacers into place using the alignment features
on the spacer and the side of the (A) housing until
the spacer screw holes and housing screw holes are
aligned. Drive the Phillips head screws through the
housing into the surrounding cabinetry.
NOTE: This step does NOT replace the anti-tip safety
hardware. Refer to Step 3 Installing Anti-Tip Bracket and
Step 5 Inserting / Securing into Cabinet Surround for
details on installing the anti-tip hardware.
Housing
A
Locating feature
on the housing
31-1000731 Rev. 3
Make sure front surface
Compartment Door
Filter
Filter Removal
Tool
Mounting Hook
Locating feature
on the spacer
Cabinet
A
Spacer
shown.
hook.
Close the compartment door.
Put the access cover back onto the unit
and secure with two 1/4" hex head screws.
Access
Cover
On the side of the access cover that will face the middle
of the installation, drive two 1/4" hex head screws. These
screws will enhance attachment of mullion trim. Repeat on
the second access cover.
Access Cover
Hole Locations
55
1/4" Hex Screws
Publicité
