Publicité
Installation Instructions - Dual Standard Installation
STEP 11 FINAL EXTERNAL UNIT PREPARATION (Cont.)
Put the access cover back onto the unit and secure with
two 1/4" hex head screws.
Access
Cover
of the installation, drive two 1/4" hex head screws.
These screws will enhance attachment of mullion trim.
Repeat on the second access cover.
Access Cover
Hole Locations
Mullion Trim Installation
Open all doors and drawers.
the dart in the area between the units.
necessary.
1/4" Hex
Screws
Open both water filter
access doors to 90°.
Snap the trim bracket
between the water fil-
ter access enclosures
above displays.
If installation requires
a
the hinge limiter pin(s)
must be installed
the top
- Open the door to expose the hole in the back hinge
42
90°
door opening,
in
hinge(s).
bracket and install the limiting pin. Pin must be fully
seated in the hinge or the door will not close properly.
Mullion
Trim
"Dart"
NOTE: Doors/Drawers not
shown for clarity.
31-1000731 Rev. 3
Publicité
