Publicité
Installation Instructions - Single Integrated Installation
STEP 6 LEVEL UNIT
All models have 4-point leveling. The front is supported
by leveling legs; the rear is supported by adjustable
wheels. Both are accessible from the front of the unit.
To level the back of the unit, turn the 7/16" hex nut
located above the front leveling legs. Turn clockwise
to raise or counterclockwise to lower the unit.
leveling leg or a 7/16" open-end wrench at the bottom
of the leveling leg.
7/16" hex nut
of unit to match
adjusts rear
installation cutout
wheels
opening 84". The
unit should be
T30 bit
level and plumb
adjusts front
with cabinetry. The
leveling legs
front wheels must
be a minimum of
1/8" (0.3 cm) off
the floor.
NOTICE: The rear leveling wheels and front leveling
legs are limited to a maximum height adjustment of 1".
If the installation requires more than 84" height, the
installer should elevate the unit on a sheet of plywood
or runners. Cabinetry trim could also be added across
the top of the opening to shorten the opening. If you
attempt to raise the unit more than 1", you will damage
the front leveling legs and the rear leveling wheels.
STEP 7 Install Door Trims
Ensure anti-tip brackets are engaged with the back of
the unit.
See Section Door Panel Adjustments and Trim
Installation for details.
STEP 8 FINAL EXTERNAL UNIT
PREPARATION
FOR FLUSH INSTALLATION:
of the door is flush
Compartment Door
with the front face of
surrounding cabinets
Filter Removal
Tool
BEFORE securing
brackets to the
surrounding cabinetry.
Open the door(s) to
removal tool if needed).
7/16" open end
wrench adjusts
front leveling legs
Make sure front surface
Filter
Mounting Hook
STEP 8 FINAL EXTERNAL UNIT
PREPARATION (Cont.)
remove. NOTE: Water
system will not function
Predrill 1/16" holes is
both the sides of the surround 1/2" deep through
holes in the enclosure.
CAUTION
Use gloves and arm guard when
installing spacers.
Secure unit to surrounding cabinetry using the
spacers and 1" Phillips screws provided with the
unit. On Single Door models: Secure the handle side
first before moving the hinge side. On French Door
models, open one door and secure that side before
moving to the other side.
Open door to full extension and pass arm through
opening between door and case to align spacers.
Slide the spacers into place using the alignment
features on the spacer and the side of the (A) housing
until the spacer screw holes and housing screw holes
are aligned. Drive the Phillips head screws through
the housing into the surrounding cabinetry.
NOTE: This step does NOT replace the anti-tip safety
hardware. Refer to Step 3 Installing Anti-Tip Bracket and
Step 5 Inserting / Securing into Cabinet Surround for
Housing
A
Locating feature
on the housing
details on installing the
anti-tip hardware.
Locate blue arrow on
align arrow as shown.
mounting hook.
Close the compartment door.
26
Locating feature
on the spacer
Cabinet
A
Spacer
31-1000731 Rev. 3
to
Publicité
