Publicité
7.4. Switching on the device
To switch on the WLAN hard drive, press and hold
the ON/OFF switch until the charge LED lights up.
The CHARGE LED flashes while the system boots
•
up.
•
The CHARGE LED is then permanently lit. The
WLAN hard drive is now ready for use.
Switching off the device
•
To switch off the WLAN hard drive, press and hold
the ON/OFF switch for about three seconds.
All LEDs switch off.
8. Operation
The WLAN hard drive is configured as a wireless access
point (AP).
Other wireless communication devices (clients) such
as tablet PCs, smart phones or notebooks can log into
the access point and thus access the data of the hard
drive via the WLAN connection.
NOTE!
When using the device as an access point
for the first time, place the client as near
as possible to the WLAN hard drive. After
successful installation, you can then set up
the hard drive at any position within range.
190 of 242
Publicité
