Publicité
- Read all the instructions before using this tool. All operators must be fully trained in its use and be
aware of these safety rules.
- Do not exceed the maximum working air pressure of 90 p.s.i./6.2 bar.
- Use personal safety equipment.
- Use only compressed air at the recommended conditions.
- If the tool appears to malfuncti on, remove from use immediately and arrange for service and
repair.
- If the tool is used with a balancer or other support device, ensure that it is fixed securely. .
- Always keep hands away from the working attachment fitted to the tool.
- The tool is not electrically insulated. Never use the tool if there is any chance of it coming into
contact with live electricity.
- When using the tool, always adopt a firm footing and/ or position and grip the tool firmly to be
able to counteract any forces or reaction forces that may be generated whilst using the tool.
- Use only correct spare parts. Do not improvise or make temporary repairs.
- Do not lock tape, wire, etc. the on/off valve in the run position. The trigger/lever etc. must always
be free to return to the 'off' position when it is released.
- Always shut off the air supply to the tool, and depress the trigger/lever etc. to exhaust air from the
feed hose before fitting, adjusting or removing the working attachment.
- Check hose and fittings regularly for wear. Replace if necessary. Do not carry the tool by its hose
and ensure the hand is remote from the on/ off control when carrying the tool with the air supply
connected.
- Take care against entanglement of moving parts of the tool with clothing, ties, hair, cleaning rags,
etc. This will cause the body to be drawn towards the tool and can be very dangerous.
- It is expected that users will adopt safe working practices and observe all relevant legal
requirements when installing, using or maintaining the tool.
- Do not install the tool unless an easily accesible and easily operable on/off valve is incoroperated
in the air supply.
- Take care that the tool exhaust air does not cause a problem or blows on another person.
- Never lay a tool down unless the working attachment has stopped moving.
-
Anticipate and be alert for sudden changes in motion during start up and operation of any
power tools.
-
Keep body stance balanced and firm. Do not overreach when operating this tools. High
reaction torques can occur at or below the recommended air pressure.
-
Tool accessory may continue to rotate briefly after throttle is relea sed.
-
Air powered tools can vibrate in use. Vibration, repetitive motions or uncomfortable positions
may be harmful to your hands and arms. Stop using any tool if discomfort, tingling feeling or pain
occurs. Seek medical advice before resuming use.
-
Prevent exposure and breathing of harmful dust and particles created by power tools use.
-
Do not use damaged, frayed or deteriorated air hoses and fittings.
-
Be sure all hoses and fittings are the correct size and are tightly secured.
-
Do not remove any labels. Replace any damaged label.
8
SECURITY INSTRUCTIONS
PROPER USE OF THE TOOL
INITIAL OPERATION
Publicité
