Jet JBS-12 Mode D'emploi page 7

Assembling the Rip Fence
The rip fence on this bandsaw can be used on either side of the
blade by fixing the rip fence extrusion (C, Fig 7) to the
appropriate side of the rip fence casting (B).
To assemble the rip fence take the rip fence casting (B) and
attach it to the bandsaw table using the M8 x 50 coach bolt and
plastic winged nut (F).
Fit the rip fence extrusion (C) to the rip fence casting (B) with
the two small knurled knobs and M6 x 40 coach bolts (D) and
use the large knob (E) for adjustment and to lock in position.
(See Fig 8).
Fig 6
Fig 7
Blade drift compensation
Use the lock knob (E) to tighten the fence profile.
The fence profile can be angled, to compensate for blade drift.
Centering the table to the blade
To centre the table to the blade loosen the 4 M8 nuts (G, Fig 9)
which hold the lower trunion to the machine frame.
Align until the sawblade runs centered through the table insert.
Re-tighten the 4 nuts.
Setting the table square to sawblade
Tools Required :- Small 90 º square (not supplied)
The table can be set at 90º to the sawblade by adjusting the
table stop screw underneath the table.
7
Fig 8
Fig 9
Fig 10