Publicité
–
Fit the kneading hook 0, whisk q or
beater w (referred to in the following as
"the attachment") to the drive shaft 7 in
such a way that the two metal pins on the
drive shaft 7 engage in the recesses of the
attachment 0 q w.
–
Push the attachment 0 q w firmly onto the
drive shaft 7 so that the spring compresses,
and rotate the attachment 0 q w anti-
clockwise a little way (towards
–
Let go of the attachment 0 q w. It is
now sitting firmly on the drive shaft 7.
5) Put the ingredients into the mixing bowl 6,
observing the following table with the recom-
mended filling quantities:
Filling quantities for...
Yeast dough
Cake mixture
Heavy dough
(e.g. shortcrust pastry)
Cream
Egg white
(weight class M)
Adapt the remaining ingredients in the recipe to
the respective maximum quantity.
CAUTION! PROPERTY DAMAGE!
►
Do not exceed the specified maximum filling
quantities!
Otherwise the appliance will be overloaded.
►
If the appliance is labouring: Switch off the
appliance, remove half of the dough and
knead each half separately.
│
GB │ IE
■
18
).
min.
max.
500 g
N/A
flour
400 g
N/A
flour
400 g
N/A
flour
200 ml
1000 ml
2
12
NOTE
►
Please note that during the kneading or stirring
process, the mixture in the mixing bowl 6
increases in volume or is pressed upward
slightly as a result of the movement. You
should therefore never fill the mixing bowl 6
right up to the top!
6) Press the release button 2
swivel arm 1 with the mounted attachment 0
q w downwards into the working position.
NOTE
If you wish, you can fit the filling accessory 8
►
onto the lid 9:
–
Press the filling accessory 8 into the
cut-out on the lid 9.
Now you can add ingredients even during
operation.
7) Push the lid 9 onto the mixing bowl 6.
8) Turn the rotary switch 3 to the required level
(see the section "Speed settings").
After you have finished using your
appliance
1) Turn the appliance off using the rotary switch 3
(Position "OFF").
2) Remove the lid 9 from the mixing bowl 6.
3) Push the release button 2
swivel arm 1 to the highest position.
4) Remove the attachment 0 q w from the drive
shaft 7 by pushing the attachment 0 q w
against the drive shaft 7 and turning clock-
wise (direction
can remove the attachment 0 q w.
5) Remove the mixing bowl 6 by turning it anti-
clockwise and then pulling it upwards.
6) Clean the appliance (see section "Cleaning
and care").
and press the
and move the
) at the same time. Then you
SKM 600 A1
Publicité
