Publicité
THERMOSTAT
Carel type:
The thermostat has been pre-set and in most cases it is not necessary to adjust the settings.
When turning on the cabinet the display will show the current temperature in the cabinet.
Display set temperature:
Press this key and the display will show the set temperature. Press the key again to
return to normal reading
Set new temperature:
Press this key continuously for more than 1 seconds and the display shows the set
temperature.
Press this key to increase the set temperature.
Press this key to lower the set temperature.
Press this key to save the new settings. The display will flash with the new value and
will then return to normal reading.
Light:
Press this key temporary to switch the light on/off.
Alarm codes:
'E0'
Flashing in the display: indicates that the cabinet sensor is defective.
The cabinet will strive to keep the set temperature until it has been repaired.
CHANGING OF PARAMETERS
Please visit this site:
https://www.carel.com/documents/10191/0/+030220791/172eda78-6c81-4ca8-aa3d-
50190c4736ba?version=1.1
Publicité
