Oven Light
The oven lights are 120 V, 40 W maximum halogen bulbs. They will
come on when the oven door is opened. The oven lights will not
work during the Self-Cleaning cycle.
When the door is closed, touch the appropriate Oven Light keypad
to turn on the oven light.
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call,
refer to the warranty, or visit producthelp.whirlpool.com. In Canada, visit www.whirlpool.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
Operation
Problem
Nothing will operate
Surface burners will not
operate
Surface burner fl ames
are uneven, yellow, and/
or noisy
Excessive heat around
cookware on cooktop
Cooktop cooking
results not what
expected
14
TROUBLESHOOTING
Possible Causes and/or Solutions
Power supply cord is unplugged: Plug into a grounded 3 prong outlet.
Household fuse is blown or a circuit breaker is tripped: Replace the fuse or reset the circuit breaker.
If the problem continues, call an electrician.
Main or regulator gas shut-off valve is in the Off position: See the Installation Instructions.
The range is improperly connected to the gas supply: Contact a trained repair specialist or see the
Installation Instructions.
The oven is in Self-Cleaning cycle: Surface burners will not operate during Self-Cleaning cycle.
The control knob is not set correctly: Push in knob before turning to a setting.
Air in the gas lines: If this is the fi rst time the surface burners have been used, turn on any one of the
surface burner knobs to release air from the gas lines.
Clogged burner ports: See the "Sealed Surface Burners" section.
Clogged burner ports: See the "Sealed Surface Burners" section.
Burner caps positioned improperly: See the "Sealed Surface Burners" section.
Range converted improperly: If Propane gas is being used, contact a service technician or see the
"Warranty" for contact information.
Cookware and fl ame are not matched: The cookware should be centered above the burner with the
bottom sitting level on the grate. The fl ame should be adjusted so that it does not extend up the sides
of the pan.
Improper cookware: Ideal cookware should have a fl at bottom, straight sides, and a well-fi tting lid,
and the material should be of a medium-to-heavy thickness.
Control knob set to incorrect heat level: See the "Cooktop Use" section.
Range is not level: Level the range. See the Installation Instructions.
To Replace:
Before replacing the bulb, make sure the oven is off and cool.
1. Unplug range or disconnect power.
2. Unscrew the oven light globe then grasp the halogen bulb and
pull out.
3. Replace bulb, using tissue or wearing cotton gloves to handle
bulb. To avoid damage to or decreasing the life of the new
bulb, do not touch bulb with bare fi ngers.
4. Replace oven light globe by screwing it back into place.
5. Reconnect power.
In Canada:
Whirlpool Brand Home Appliances
Customer eXperience Centre
200 - 6750 Century Ave.
Mississauga, Ontario L5N 0B