Publicité
Les langues disponibles
Les langues disponibles
Instalación / Instalação / Installation / Installation
Distancias mínimas / Distâncias mínimas / Minimum distances / Distances minimales
Note: There are ventilation holes around outside of the hob. YOU MUST ensure these holes are not blocked by the worktop when yo u put the hob into
position.
Be aware that the glue that join the plastic or wooden material to the furniture, has to resist to temperature not below 150 ℃, to avoid the unstuck of the
paneling.
The rear wall, adjacent and surrounding surfaces must therefore be able to withstand an temperature of 90℃.
2. Before installing the hob, make sure that
The work surface is square and level, and no structural members interfere with space requirements.
The work surface is made of a heat-resistant and insulated material.
If the hob is installed above an oven, the oven has a built-in cooling fan.
The installation will comply with all clearance requirements and applicable standards and regulations.
A suitable isolating switch providing full disconnection from the mains power supply is incorporated in the permanent wiring, mounted and positioned to comply with
the local wiring rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm air gap contact separation in all poles (or in all active [phase] conductors if the local wiring rules
allow for this variation of the requirements).
The isolating switch will be easily accessible to the customer with the hob installed.
You consult local building authorities and by-laws if in doubt regarding installation.
You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces surrounding the hob.
3. After installing the hob, make sure that
The power supply cable is not accessible through cupboard doors or drawers.
There is adequate flow of fresh air from outside the cabinetry to the base of the hob.
If the hob is installed above a drawer or cupboard space, a thermal protection barrier is installed below the base of the hob.
The isolating switch is easily accessible by the customer.
4. Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply force onto the controls protruding from the hob.
5. Adjusting the bracket position
Fix the hob on the work surface by insert 4 brackets on the bottom of hob(see picture) before installation.
Adjust the bracket position to suit for different table top thickness.
Unidades en mm / Unidades em mm / Units in mm / Unités en mm
bracket
EN
5
Publicité
