Publicité
For any repairs or maintenance, contact the Ridge Tool
Company, Technical Service Department at (800) 519-
3456 or www.RIDGID.com for nearest authorized press
tool service outlet.
If you have any questions regarding the service or repair
of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: TechServices@ridgid.com
For name and address of your nearest Independent
Authorized Press Tool Service Center, contact the Ridge
Tool Com pany at (800) 519-3456 or www.RIDGID.com
Disposal
The RBRC™ (Rechargeable Battery
Recycling Corporation) Seal on the
battery packs means that RIDGID
has already paid the cost of recycling
the lithium-ion battery packs once
they have reached the end of their
useful life.
RBRC™, RIDGID
®
, and other battery suppliers have
developed programs in the USA and Canada to collect
and recycle rechargeable batteries. Normal and recharge-
Troubleshooting
SYMPTOM
Tool will not turn ON
when ON/OFF button on
display panel is pressed.
Tool turns OFF either
when trigger is de -
pressed or in the middle
of a press cycle. Red
LED glows.
Yellow LED blinks
repeatedly as long as
tool is turned ON and
tool functions properly.
All manuals and user guides at all-guides.com
POSSIBLE REASONS
Battery is completely discharged or battery has
failed.
Battery not properly inserted into handle of tool.
Battery is too low.
Tool or battery is too cold or too hot.
Scheduled maintenance/recalibration is required
after 30,000 presses.
Ridge Tool Company
RP 210 Press Tool
able batteries contain materials that should not be direct-
ly disposed of in nature, and contain valuable materials
that can be recycled. Help to protect the environment
and conserve natural resources by returning your used
batteries to your local retailer or an authorized RIDGID ser-
vice center for recycling. Your local recycling center can
also provide you with additional drop off locations.
RBRC™ is a registered trademark of the Rechargeable
Battery Recycling Corporation.
Machine Disposal
Parts of this unit are valuable materials and can be
recycled. There are companies that specialize in recy-
cling that may be found locally.
Dispose of in compliance with any and all applicable reg-
ulations. Contact your local waste management author-
ity for more information.
Insert fully charged battery/recharge dead battery.
Check to assure battery is fully inserted.
Insert fully charged battery/recharge dead battery.
Bring tool and battery to correct operating range
between 0°F (-20°C) to 122°F (50°C) by allowing
the tool to sit in a conditioned room. If using tool
in cold temperatures, refer to Cold Weather
Operation Section of this manual.
NOTE! Fitting must be repressed if tool stops
in the middle of a press cycle. Failure
to do so may result in a leaking fitting.
Contact Ridge Tool Company, Technical Service
Department at (800) 519-3456 for nearest
Authorized Press Tool Service outlet.
SOLUTION
11
Publicité
