Télécharger Imprimer la page

DeWalt DCL182 Traduction De La Notice D'instructions Originale page 14

Publicité

EnGLIsh
RECHARGEABLE LED TASK LIGHT
DCL182
Congratulations!
You have chosen a D
WALT product. Years of experience, thorough
e
product development and innovation make D
most reliable partners for professional power tool users.
Technical Data
Voltage
Type
Lumens
Articulating head LED
Light Beam Angle
Articulating head LED
Run Time When Fully Charged
Articulating head LED
WARNING: To reduce the risk of injury, read the
instruction manual.
Definitions: Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to
these symbols.

DANGER: Indicates an imminently hazardous
situation which, if not avoided, will result in death or
serious injury.

WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or
serious injury.

CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderate injury.
NOTICE: Indicates a practice not related to
personal injury which, if not avoided, may result in
property damage.

Denotes risk of electric shock.

Denotes risk of fire.
SAFETY INSTRUCTIONS
When using an electrical light, basic precautions should always be
followed, including the following:

WARNING: Do not attempt to modify or repair the light.
12
WALT one of the
e
DCL182
V
3.6
DC
1
Low - 250
lm
Mid - 500
High - 1000
degrees
120
Low - 12
hours
Mid - 8
High - 3.5

WARNING: Do not charge the battery at ambient
temperatures below 4 °C (40 °F) or above 40 °C
(104 °F). Follow all charging instructions and do not
charge the battery outside of the temperature range
specified in the instructions. Charging improperly or at
temperatures outside of the specified range may damage
the battery and increase risk of fire.
Shock Hazard. To protect against risk of electrical shock, do
not put charging base in water or other liquid.
Do not allow to be used as a toy. Close attention is
necessary when used near children.
Do not use if damaged. If light is not working as it should,
has been dropped, damaged, left outdoors, or dropped into
water, return it to a service center.
Do not incinerate the light even if it is severely damaged.
The batteries can explode in a fire.
Do not pull or carry by charging cord, use charging
cord as a handle, close a door on charging cord, or pull
charging cord around sharp edges or corners.
Keep charging cord away from heated surfaces.
Do not allow the cord to hang over the edge of a table or
counter or touch hot surfaces. The unit should be placed or
mounted away from sinks and hot surfaces.
Do not unplug by pulling on charging cord. To unplug,
grasp the plug, not the cord.
Do not handle charging cord, including charging plug
with wet hands.
Do not charge the unit outdoors.
Leaks from battery cells can occur under extreme
conditions. If the liquid, which is a 20-35% solution of
potassium hydroxide, gets on the skin (1) wash quickly with
soap and water or (2) neutralize with a mild acid such as
lemon juice or vinegar. If the liquid gets into the eyes, flush
them immediately with clean water for a minimum of 10
minutes. Seek medical attention.
The light source of this luminaire is not replaceable;
when the light source reaches its end of life the whole
luminaire shall be replaced.
Additional Safety Warnings
a ) This light is intended for professional, commercial or
industrial use.
b ) Do not use a battery or light that is damaged or modified.
Damaged or modified batteries may exhibit unpredictable
behavior resulting in fire, explosion or risk of injury.
c ) Do not expose a battery to fire or excessive
temperature. Exposure to fire or temperature above
130 °C (266 °F) may cause explosion.
d ) Do not use magnet for overhead mounting.
e ) The luminaire should be powered by certified power supply
with SELV output (constant voltage 5 Vdc).
SAVE THESE INSTRUCTIONS

Publicité

loading