FLORABEST HG03601 Instructions De Montage, D'utilisation Et Consignes De Sécurité page 6
Masquer les pouces
Voir aussi pour HG03601:
Publicité
on the same level and stand column on the ho-
rizon. Otherwise, the fabric will be deformed
and there will be difficulty on opening and
closing (see fig. A).
Secure and close the product in extreme
weather, e.g. strong wind.
Verify the product is mounted properly before use.
Set the product on a level, firm surface.
This product is not a toy and should only be
used under adult supervision.
Check the product for damage or wear before
each use.
Do not use the product close to a naked flame.
We recommend that two persons assemble the
product together in order to avoid injuries or
damage to people or the product.
Do not release handle
stand
, until it is fixed in the casket
4
Releasing handle
2
result in damage and / or injury.
The operation in frosty conditions may damage
the product.
There is no maintenance required by the user.
Wind resistance class 1 = wind beaufort scale
4 = 20-27 km/h (small branches start to move,
loose paper is lifted)
Assembly instructions
Use cross screwdriver for fixing the brackets
on the product with screws
(see fig. B).
First locate a suitable installation position on a
wall and mark four hole positions of the brackets
(see fig. C).
5
Drill 9-centimeter-deep holes in the marked places
with a broach which has a diameter of 10 milli-
meters (see fig. D).
Fix into holes anchor plugs
on the wall with mallet (see fig. E).
Important: Make sure before locating anchor
plugs are suitable for surface type. If not suitable,
consult your local hardware or DIY store.
Fix the product on the wall with M6 x 60 hexa-
gon screws
and washers
7
6
GB/IE/NI
after removing from
2
.
1
without attention may
5
and washer
11
10
into the four holes
6
(see fig. F).
10
Locate the fixing stand
casket
and stand
1
4
aligned. Fixing stand
4
max. 300 cm from casket
the fixing stand holes and drill as per figure G.
Make four holes for fixing the stand and drive
plastic anchor bolts
6
the ground with M8 x 75 hexagon screws
and washers
(see fig G).
9
Opening awning (see fig. H)
Hold the handle
and walk to the fixing
2
stand
.
4
Insert the axis pin
(under the handle
3
into the axis pin hole on the top of stand
Insert the front bar
into the pin
13
of stand).
Closing awning (see fig. I)
Hold the handle
and pull back a little bit
2
(There is a groove to lock the handle
fixing stand
, so it is hard to pull up directly.)
4
and lift up.
Grasp the handle
and walk to the casket
2
Move the handle
slowly and horizontally.
2
The fabric will draw back itself into the casket
Cleaning and care
Allow all parts to dry thoroughly before you
pack the product up again.
This will prevent the formation of moulds, odours
and discolouration.
Clean this product with a slightly dampened,
lint-free cloth.
Store the product in a sheltered room. Or always
store the dry and clean product at room tem-
perature.
position ensuring
4
are at same level and
can be mounted at
(see fig A). Mark
1
in. Set the stand
on
4
8
)
2
.
4
(bottom
12
and
2
.
1
.
1
Publicité
