Publicité
3.
Install the bagger screen into the bagger cover by first inserting
the end closest to the side with the cutout into the
mounting hole, as in Fig. 4-13. Make sure to feed the screen
under the lip, as in Fig. 4-14.
Figure 4-13
4.
Clip in the other side by pushing the screen into the provided
cutout. See Fig. 4-14.
Make sure screen sits
under the cover's lip
Figure 4-14
5.
Install the bagger cover onto the bag support assembly, as
seen in Fig. 4-15. The plastic cover goes inside of the two
mounting tabs.
6.
Slide the hinge pin into the hole located on the mounting tab, as
in Fig. 4-16. Use the cut-out window (See inset in Fig. 4-16)
to line up the hinge pin on the other side and push pin all
the way in until it reaches the end-stop. At this point the
pin clips into place and is secured by a tab in the bagger
cover. See Fig. 4-17.
Figure 4-15
Figure 4-16
Figure 4-17
s
4 — a
& i
ectiOn
sseMbly
nstallatiOn
13
Publicité
