Publicité
Wiring Directions
1.
Turn off all power to the light fixture by switching off
the circuit breaker.
2.
Open the fixture cover and remove the cover for the
driver cavity. The driver and its wiring should now be
visible.
3.
Utilizing a voltmeter, verify power is off to the driver. If
power is present, stop work, identify ad switch off the
circuit breaker.
4.
Disconnect the "Hot" wire (Line) of the driver.
5.
Connect the black wire (Line) from the Flex Conduit
of the Accessory to the "Hot" wire (Line) input power
using a wiring connector. (Use Supplied Lever Nut).
6.
Connect the AC input "Hot" wire (Line) of the driver to
the Black with White Strip wire from the flex conduit
using a wiring connector. (Use Supplied Lever Nut).
7 .
Connect the white wire (Neutral) from the flex conduit
to the white wire (Neutral) of the incoming power using
wiring connector. (Use Supplied Lever Nut).
8.
Connector the Neutral wire of the driver to the White
with Black Stripped wire from the flex conduit using a
wiring connector. (Use Supplied Lever Nut).
0-10 V
DRIVER
4.5A MAX.
Figurt 5.
Installation Instructions – PORLWTPD1
9.
Connect the violet wire (+) from the dimming driver
to the violet wire of the flex conduit using a wiring
connector, (or plug the violet wire from the flex conduit
directly into the positive control terminal of the LED
driver). This cNnntcoiNn shNuld bt stparaotd frNm
high vNloagt by rNuoing oht cablts oN oht lNw
vNloagt dividtr bNx.
10. Connect the gray wire (-) from the dimming driver
to the gray wire of the flex conduit using a wiring
connector, (or plug the gray wire from the flex conduit
directly into the negative terminal of the LED driver).
This cNnntcoiNn shNuld bt stparaotd frNm high
vNloagt by rNuoing oht cablts oN oht lNw vNloagt
dividtr bNx.
Figurt 4.
POR-LWTPD1
7 FT. SENSOR CABLE
LINE INPUT
120-277V 50/60 HZ
IL520007EN
EATON
(INCLUDED)
LumaWatt Pro
SU-4E-01
SENSOR
(INCLUDED)
Installation instructions
3
Publicité
