Publicité
Notice d'assemblage ECblue BASIC-MODBUS, ECblue BASIC
Note: If AM-MODBUS-W module or AM-PREMIUM-W module is used and installed by the user, the
FCC/IC label (AM-MODBUS-W inside label for AM-MODBUS-W module, EM-W inside label for AM-
PREMIUM- W module) have to stick on the housing of the ECblue.
Sticking the AM-MODBUS-W inside label on the
ECblue housing.
Note: The modules (AM-MODBUS-W and AM-PREMIUM-W) are stricly limited for the integration and
usage with host devices manufactured by ZIEHL-ABEGG SE.
1.5.2
FCC Statements for US @ AM-MODBUS-WB, AM-STICK-WB
FCC Notice
This device contains FCC ID: T7V1740 (PAN1740), including the antennas, which are listed below,
complies with Part 15 of the FCC Rules.
The device meets the requirements for modular transmitter approval as detailed in FCC public Notice
DA00-1407 transmitter.
Operation is subject to the following two conditions
1. this device may not cause harmful interference
2. this device must accept any interference received, including interference that may cause undesi-
red operation
Caution
The FCC requires the user to be notified that any changes or modifications made to this device that
are not expressly approved by ZIEHL-ABEGG SE may void the user's authority to operate the
equipment.
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help
Labeling Requirements
The Original Equipment Manufacturer (OEM) must ensure that FCC labelling requirements are met.
This includes a clearly visible label on the outside of the OEM enclosure specifying the appropriate
Panasonic FCC identifier for this product as well as the FCC Notice above. The FCC identifier is FCC
ID: T7V1740. This FCC identifier is valid for all PAN1740 modules.
In any case the end product must be labelled exterior with "Contains FCC ID: T7V1740"
L-BAL-F078D-F 2024/23 Index 009
Sticking the EM-W inside label on the ECblue hous-
ing.
Art.N°. 00706648D-F
6/64
Instructions générales
Publicité
