Publicité
ENGLISH
7.4 Fuse Replacement
Prior to fuse replacement, ensure that Multimeter is
disconnected from external voltage supply and the other
connected instruments (such as UUT, control instruments, etc.)
Only use fuses as described in the technical data section!
Fuse (A): FF 630mA
Fuse (A): F 10 A
Using auxiliary fuses, in particular short-circuiting fuse holders is
prohibited and can cause instrument destruction or serious bodily injury
of operator.
To replace a fuse:
•
Switch off the instrument. Disconnect all test leads.
•
Loosen the screws on the instrument rear.
•
Lift the case cover.
•
Remove the defect fuse.
•
Insert new fuse.
•
Replace the case cover and retighten the screws.
8.0 Technical Data
Display:
Total Display:
Polarity display:
Measurement Category:
Pollution Degree:
Power Supply:
Dimensions:
Weight:
1000 V Ceramic 6.3x32 mm
1000 V Ceramic 10x38 mm
3¾ digit, LC display
6000 Digits
Automatically
CAT IV/ 600V; CAT III / 1000V
2
Batteries, 3 x 1,5V IEC LR03, AAA
170 x 82 x 26 mm
280 g
26
Publicité
