Publicité
Cutting straight edges
Do not force - a steady even pressure will cut just
as well. If undue force is needed, check for
alignment of riving blade, cutting guide or blade
support.
Making diagonal cuts
Use the diagonal cutting guide as shown, keeping
both the tile and guide firmly pressed against the
fence as you cut.
Cutting 45 and 22.5 mitres
Lift up right hand side of the work top, bend out
the support legs so that they wedge into the top of
the pillars on each side of the water reservoir. this
is done using each thumb inside to spring out both
legs together.
Tiles should be cut face down on the right table
top. It is recommended that the tile guide be
snapped into place creating a small flat on the left
edge to avoid sharp edges and chips.
Publicité
