Publicité
The rechargeable battery is firmly integrated into
the base of the product.
Note: Fully charge the product before first use.
Note: Charge the product at least once a month, if
it is to remain unused for an extended period of time.
Note: If the product has not been charged for an
extended period of time (approx. 2 months), you
could find that the integral rechargeable battery
has entered a dormant state. Charge and discharge
the product a number of times in succession to
reactivate the integral rechargeable battery.
Note: You can choose to charge the product directly
via the mains adaptor
12
Before charging, switch the product off (press
ON / OFF switch
3
To charge the product via mains adaptor
directly, connect the USB cable
USB connector of the mains adaptor
then connect the USB (type C) connector on
the USB cable
to the USB (type C) input
11
socket
of the LED torch.
6
To charge the product via the charging station,
connect the USB cable
tor of the mains adaptor
the USB (type C) connector on the USB cable
to the USB (type C) input socket of the
11
charging station
10
into the charging station to charge the prod-
uct (see fig. B).
Note: The product is fitted with an overcharge
protection circuit. Despite this, you should dis-
connect the LED inspection lamp from the power
supply after the charging process is complete.
Note: The green charging indicators (LED
torch)
will light up and flash during charg-
4
ing. There are 4 indicator lights showing the
charging progress (approx. 25 % / 50 % / 75 % /
100 %). When the indicator continually light
on mean the represented charging progress
was finished. When charging is complete, all
indicator light up without flashing. Pull the mains
adaptor
out of the socket. Disconnect the
12
mains adaptor
12
the rechargeable battery from discharging.
or via the charging station.
).
with the
11
and
12
with the USB connec-
11
and then connect
12
. Then place the product
from the product to prevent
Use
Q
CAUTION! RISK OF ACCIDENT! Always
store and secure the product in such a way that there
is no risk of injury from or damage to the product.
Note: The product may be secured with the hook
or by securing it to a flat, ferromagnetic surface
5
using the magnetic base
the back. You can tilt the product up to 180 ° on
the magnetic base
CAUTION! Please note the position of your hands
whilst turning the magnetic base
pinching your fingers (see Fig. D).
U sing the product without
12
a power connection
F ully charge the product as described in the
section "Charging the product".
The product can be operated in 4 different
modes, select these by:
Repeatedly pressing the ON / OFF switch
Press once:
Press twice:
Press three times: Switches the side light
Press four times:
Corded use of the product
U se the included mains adaptor
pose. Using the respective mains adaptor
connect the product to a suitable power supply.
T hen proceed as described under "Using the
product without a power connection" (starting
with step 2).
Note: The product can only be charged
whilst off!
or the magnet
8
.
8
to prevent
8
The side light
lights up
2
with white light.
The side light
turns to
2
UV light mode.
off and switches on the
spotlight
.
1
Switches off the product.
for this pur-
12
GB/IE
at
7
.
3
2
,
12
17
Publicité
