Publicité
Using the surface elements.
Using the Timer
• You can set it to turn one cooking zone off after the set time is up.
• You can set the timer up to 99 minutes.
Setting the Timer to Turn off One Cooking Zone
1. Touch the heating zone selection control that you want to set the timer for.
2. Touch timer control, the minder indicator will start flashing and "30" will show in
the timer display.
3. Set the time by touching the "+" and "-" buttons.
Hint: Touch the "-" or "+" control of the timer once - time will decrease or increase
by 1 minute.
Touch and hold the "-" or "+" control of the timer - time will decrease or increase by
10 minutes.
Slide the controller from left to right or from right to left - time will increase or
decrease by 10 minutes.
4. Touch the "-" control to reduce the time outstanding to zero or press the "timer
control" when the "00" shows in the minute display to cancel the timer.
5. When the time is set, it will begin to count down immediately. The display will
show the remaining time and the timer indicator will flash for 5 seconds.
NOTE:
The red dot next to power level indicator will illuminate, indicating that zone
is selected.
6. When cooking timer expires, the corresponding cooking zone will switch off
automatically.
7. Timer for multiple heating areas delay off, the shortest delay off time will be
shown on display. To check remained delay off time of other heating area, you
should press button for different heating area.
!
Other cooking zones will keep operating if they have been turned on previously.
Countdown timer
The countdown timer operates independently and it is not related to the operation of any cooking zone.
1.Touch timer control, the minder indicator will start flashing and "30" will show in the timer display.
2.Set the time by touching the "+" and "-" buttons.You can set the timer up to 99 minutes.
3.When the time is set, it will begin to count down immediately.
4.When countdown timer expires, the buzzer beeps 20 times to remind the user.
Keep warm
To turn on
1.Touch the heating zone selection control that you wish to keep warm.
2.Touch the "keep warm" key once to enter mode 1, the corresponding display will show"
this case, food temperature is maintained at around 42 °C (107.6 °F).
3.Touch the "keep warm" key twice to enter mode 2, the corresponding display will show"
this case, food temperature is maintained at around 70 °C (158 °F).
4.Actual temperature may depend on the type of cookware and amount of food.
To turn off
1.Touch the heating zone selection control that you wish to turn off.
2.In mode 2 state, touch the "keep warm"key again, the corresponding display shows"-",the keep
warm function will be turned off.
3.The keep warm function can work for max. 8h. If no any key are touched, the active cooking
zones will be automatically switched off after 8h.
Using the Bridge （Maximum power 3000W Boost 3600W）
To Turn On a Bridge:
1. Touch the desired Left side bridge.
Indicator above the left side bridge will be illuminated. The heat setting levels for the cooking areas
will default to "0" and can be set from a minimum of "1" to a maximum of "P." Any timers that may
be running for the cooking areas will turn off, and 2 dashes "--" will appear in the timer display.
8
6
30
36
or
00
36
6.
"；in
"；in
Publicité
