Télécharger Imprimer la page

RedMax CV48 Manuel D'utilisation page 26

Publicité

MAINTENANCE
3. Adjust the neutral bolt on the left side of the
unit so the plunger on the neutral switch is
flush with the surface of the switch.
4. Go to the right side of the unit and back
the bolt out so the bolt is not contacting the
plunger.
On the right side:
5. Start tightening the right
or two turns at a time. Between tightening,
attempt to start the unit, but be sure to keep
fingers or loose articles of clothing away from
the pump fans.
6. Continue tightening the
unit attempts to start (it is not necessary to
keep the unit running if it fully starts up).
7. Tighten the
neutral
full turn and then tighten down the jam nut.
To prevent bending the bracket, do not over
tighten.
On the left side:
8. Loosen the left
neutral
contacts the plunger on the switch.
9. Tighten the bolt one to two turns and attempt
to start the unit between each adjustment.
When the unit attempts to start, tighten the
bolt one half to one full turn and tighten the
jam nut.
Caster Wheels
Check every 200 hours. Check that wheels rotate
freely.
To replace, remove nut and caster bolt. Pull the
wheel out of the fork. Install in reverse order.
Tighten caster bolt. Torque to 50 ft-lbs (67.8 Nm).
NOTE: Tire must rotate freely but axle spacers
must not. If wheels do not rotate freely take the
unit to the dealer for service.
26
neutral
bolt one to
neutral
bolt until the
bolt an additional half to
bolt until it no longer
Cleaning
CAUTION! Always wear eye
protection when cleaning or washing
the mower.
Regular cleaning and washing, especially under
the mower deck, will increase the machine's life-
span. Make it a habit to clean the machine directly
after use (after it is cooled), before the dirt sticks.
Do not spray water on the top of the mower deck.
Use compressed air to clean the top side of
mower deck. Regularly clean deck and underside
of the deck with normal water pressure. Do not
use a high pressure washer or steam cleaner.
Avoid spraying engine and electrical components
with water.
Do not rinse hot surfaces with cold water. Let unit
cool before washing.

Publicité

loading

Ce manuel est également adapté pour:

97046520100