Publicité
4. Repeat steps 2 and 3.
NOTE: Make sure the magnet in the right of each long shelf
edge is facing out.
P1
A
A. Magnet facing outward
Adjust the Shelves
1. Lift up on the underside of the shelf until the shelf tabs are free
of the cabinet slots.
2. Tilt the shelf up to reposition it within the cabinet or to remove
it from the cabinet.
Install Doors
IMPORTANT:
F3c. Phillips-head screw (12)
The door with the lock assembly (P7) should be installed on the
■
right-hand side of the cabinet.
The door hinges are designed with keyhole slots at the top
■
and bottom so the door will hang on the cabinet while you are
fastening the screws.
1. Start Phillips-head screws (F3c) in both the top and bottom
holes on each side of the cabinet.
2. Hang the right-hand side door (P7) from the top and bottom
screws, and hand tighten.
6
P2
P1
P5mr
P5mr
P3
F3
F3c
3. Insert the middle 4 screws through the door hinge into the
cabinet and hand tighten.
P2
P1
P7
A
P5mr
P5mr
P3
A. Phillips-head screw
4. Repeat steps 2 and 3 to attach the left-hand door (P6).
5. Align the doors and completely tighten the door screws.
Complete Assembly
1. Make sure there is a bolt or screw in each hole of the cabinet
frame.
2. Move the cabinet to its final location.
3. Place a level on an inside shelf, and if necessary, level the
cabinet by adjusting the height of the leveling legs. Turn to the
left to raise or to the right to lower the leveling leg.
4. If the doors are not aligned, loosen all the screws attaching
the door hinge to the cabinet.
5. Adjust door to the desired height, and fully tighten the screws.
ACCESSORIES
To order accessories, call 1-866-342-4089 and ask for the
accessory part number listed below or contact your authorized
Gladiator
GarageWorks dealer. In Canada, call 1-800-807-6777.
®
Mounting Bracket Kit - Allows the cabinet to be mounted
on Gladiator
Garageworks GearWall
®
channels.
Order Part # GABK362PSS
panels or GearTrack
®
®
Publicité
