Publicité
6. Using the Hex key (provided), completely tighten all cabinet
bolts and nuts.
P1
P3
Install Leveling Legs
(optional)
IMPORTANT: If you are going to install the cabinet on Gladiator
GearWall
panels or GearTrack
®
install leveling legs.
1. Place the cabinet on its side.
2. Screw a leveling leg (P4) into each of the four rivet nuts
located at the corners of the cabinet as shown.
P1
A. Leveling legs
3. Stand the cabinet upright.
4. If you have not already done so, fasten the two bolts at each
front corner, of the cabinet frame. Completely tighten all of the
cabinet bolts and nuts.
Install Shelves
IMPORTANT:
The shelves are supported by the metal slots on the cabinet
■
sides.
Make sure the magnet in the right of each long shelf edge is
■
facing out.
P2
P1
channels, you do not need to
®
P4
P3
A
1. Place a shelf (P5mr) so that the 2 tabs in the shelf ends are
aligned with the pair of slots in the middle of the cabinet
sides.
P1
2. Tilt the shelf so that one end is higher than the other as
shown.
B
A. Push down
B. Lift up
3. Insert the shelf into the cabinet so that the higher end is
directly above the desired slots and push the shelf down into
place behind the side slots. Raise the lower end so it is
directly above the desired slots and push the shelf down.
NOTE: You may need to slightly bend the shelf tabs outward
for the tabs to engage in the slots. Make sure the shelf tabs
are in place behind all the slots, as shown.
A. Cabinet slot
B. Shelf tab
P2
P1
P5mr
P3
A
A
B
5
Publicité
